SXC30-750 hydraulic presses Sheet metal processing machine

Measured data and reference conditions — SXC30-750

Values per the model datasheet. Each paragraph is self-contained and states the test condition, the value and the comparison baseline.

Throat depth for large panels

Test condition: punching in the middle of a wide busbar. Value: a 750 mm throat depth with a 60 mm maximum processing diameter at 300 kN. Comparison baseline: a bench press with a short throat, which can only reach the edge of a wide bar. Effect: holes located well inside a wide bar are punched without repositioning the part.

Thickness and diameter limit

Test condition: punching the maximum hole diameter in the maximum thickness. Value: up to 60 mm diameter in material up to 6 mm thick, at 300 kN nominal pressure. Comparison baseline: hand punches, which are limited both in diameter and in thickness. Effect: the large-diameter, thin-plate combination typical of busbar covers is handled by one press.

Rate with PLC step control

Test condition: repeated punching under PLC control with the digital axis system. Value: step speed up to 12 times per minute, with the machine able to stop during unattended operation. Comparison baseline: manual press cycles, where speed depends on the operator and the machine cannot be left alone. Effect: the operation becomes a settable cycle rather than an operator-paced task.

Frame stability over time

Test condition: long-term operation of a steel plate welded bed. Value: stress annealing after welding, so the frame does not deform after long-term use, on a 300 kN press with a high-flow gear pump. Comparison baseline: frames welded without stress relief, which distort and lose alignment. Effect: punch-to-die alignment is retained over the life of the machine.